May 17, 2012
If there is anything consistent among a group of skydivers, it’s the fact that we all want to make more skydives! Often what stops us is money or time, but other times it’s just plain running out of daylight. We can’t hold the sun up in the sky to get more time, but every skydiver can work to make aircraft boarding more efficient and thus allow more loads in a day and more skydives for us!
So here’s the scoop:
- Be at the loading area at least by the 5-minute call.
- Use the time to look around the loading area and see what other skydivers are on your load, and work together to plan what the exit order should be (and the reverse, what the loading order should be). There may be someone already doing this for your load, or there might not. Don’t be afraid to take charge and ask who’s doing what and work it out yourself.
- Be in line ready to board as the plane pulls up. Don’t sit back on the benches until the group ahead of you is fully in the plane, working on that last smoke or what have you.
So what should the proper exit order be with different types of skydives? Here’s how we load the plane at Spaceland (exit order is the reverse, of course):
- First to board: Wingsuits
- Tracking dives (first or last before wingsuits)
- Skydiver Training Program Students
- Freefly groups, smallest to largest.
- Belly-fly groups, smallest to largest.
- Last to board, first to exit: Any lower-altitude individuals or groups.
Why, you may ask, did we pick this order? The answer is that we want to ensure as much horizontal separation between groups as possible. Vertical separation is nice, but it just doesn’t always cut it. What if that group that exited behind you and ended up on top of you has a cutaway? This is NOT what we want. So we’re back to horizontal separation, and consideration of freefall drift.
Think of the plane flying into the wind and skydivers falling straight down as they exit (yes, we know people don’t always fall straight down, but stay with me here . The wind will affect us all the same according to how much time we spend in it, and think about that. The slower fallers will spend more time in the wind (potentially 20 seconds longer) and thus will drift further downwind than the faster fallers. This is why the belly flyers get out first… they will drift further aft of the exit point while the freefallers will get to their pull altitude sooner.
Students and tandems get out later as they are generally pulling significantly higher and this way they are not in the way of later jumpers pulling lower.
You may be asking why we put tracking dives and wingsuiters out last, since they will fall slower than freeflyers and pull lower than tandems. It’s a great question. Usually what’s happening at this point is that the rest of the load is out and the spot is getting pretty long. The aircraft may do a partial turn back toward the drop zone, or depending on the preferences of the jumpers and pilot it may just keep going further away. Either way, the spot’s getting pretty long and tracking dives/wingsuiters are both falling slower than typical freefall speeds and are moving around in the sky quite a bit, which allows them to get back toward the drop zone while staying clear of other groups (for example, if they went out first and ended up tracking partly up line of flight, they could very easily end up under other groups). Often trackers and wingsuiters will hold their exit for an even longer spot so they can safely do the ground-covering activity they like.
On the other hand, if trackers get out first and track down or across line of flight, that can work too.
As always, if you have any questions about exit or loading order, check in with one of our instructors. Never be afraid to ask!